Solved: Blind Fret Slots - Help Needed - Autodesk Community

Ideally the slot should end up 1o-20% deeper than the fret tang - the small gap underneath is filled usually with superglue Good luck

Just remember that the slot depth equals the height of the blade sticking up past the bed of the sled Also

fret slot width HOSCO Fret Saw Guide How to use · 1 At first, please note 2 points 1) This fret saw guide can adjust 0mm to slot depth by sliding the frame · 2 Loose

fret slot depth depth guide The perspex fret saw depth guid