Fret Slotting Mitre Jig

Perspex Fret Slotting Saw depth guide With brass thumbscrews to fit the Tonetech fret slotting saw Depth is adjustable from 1mm to 6mm The guide is made

Fret Slotting Mitre Jig You generally only use a table saw to cut fret slots when the fretboard is still flat Then after radiusing you just use a hand fretsaw with a

Perspex Fret Slotting Saw depth guide With brass thumbscrews to fit the Tonetech fret slotting saw Depth is adjustable from 1mm to 6mm The guide is made

slot games for android phones Every guitar I've ever re-fretted had slots that were deeper than the fret tangs; often by a fair amount Filling in the ends of the slots IS

Perspex Fret Slotting Saw depth guide With brass thumbscrews to fit the Tonetech fret slotting saw Depth is adjustable from 1mm to 6mm The guide is made

fret slot width Fret slots don't need to follow the radius of the fingerboard As long as they are the correct depth on the ends of the frets, having the middle deeper dosen't

Ideally the slot should end up 1o-20% deeper than the fret tang - the small gap underneath is filled usually with superglue Good luck