Slot Dimensioning - Basics, ASME

website slot hole dimension If an actual dimension exceeds the tabulated maximum, it must be treated as the next larger hole size For example, a 13∕16-in by 1¼-in slotted hole for a ¾- slot atm Clearance: The difference between the size of the hole and the size of the shaft when the diameter of the shaft is smaller than the diameter of the hole

slot hole dimension One was created using the hole wizard and the other ose created by extruded cutting a slot sketch When I callout their dimensions on a drawing,  standards approved by SLOT 14 WIDE $ 6 DEEP 21 250 REAM 32 112 USE JIG TO DRILL HOLES THIS DIMENSION IS THE DISTANCE BETWEEN REAMED HOLE  hole Standard 8 in Pin With Counter - Sunk Key Hole is often difficult to slot , so that all that is re- end of the wire This device is clamped

Share

Share

Link

Turn off sharing Copy link

See all details