Tab and Slot - 2022

Tab and Slot - 2022 tab and slot I make a lot of weldments and sheet metal parts that are 12ga to 12in thk, I use 132 per side for the slot Be mindfull if you have tabs on tab and slot welding table The required selections for the Tab and Slot feature are the edge to add tabs to and the face for the slots The tabs can be offset from either

tab and slot welding table Table of Contents The business card holder below was created as an example to illustrate the benefits of the Tab & Slot feature An additional

tab and slot solidworks 005- 010 over the thickness for the width of the slot for cold rolled I normally make the slot longer than the tab by about 050 After This feature can be used on single bodies, multibody and parts in the context of an assembly Not